Snarkpit Forum Index » Source engine editing » sliding door stopping half way or 3/4 way
sliding door stopping half way or 3/4 way
1
Post Reply
Quote
 Re: sliding door stopping half way or 3/4 way
Posted by LIVEWIRE898 on Sat Nov 27th at 11:57pm 2004

Ok I am trying to make a door that slides up and what i want it to do is to stop 1/2 way or 3/4 way to give it the effect that its broken.... but when I apply the func_door and set it to slide up it seems that it wants to move up the entire height of the brush... Is there any way to make the door stop half way through?



Quote
 Re: sliding door stopping half way or 3/4 way
Posted by Orpheus on Sun Nov 28th at 12:41am 2004

? quoting LIVEWIRE898
Ok I am trying to make a door that slides up and what i want it to do is to stop 1/2 way or 3/4 way to give it the effect that its broken.... but when I apply the func_door and set it to slide up it seems that it wants to move up the entire height of the brush... Is there any way to make the door stop half way through?

assuming its still like HL1, set the "lip" for a different value..

may be more, or less i suppose, depending on the direction of travel.

try decreasing it by 100

[addsig]




1
Post Reply