Snarkpit Forum Index » Source engine editing » crooked door bad door
crooked door bad door
1
Post Reply
Quote
 Re: crooked door bad door
Posted by Snookay on Tue Jan 25th at 12:22am 2005

ok i made 2 doors and 4 buttons. 1 button on each side of both the doors. the door on the left is bad, the door on the right is good. I shoot or press button and the doors are suppoes to go down or up. well the door on the left starts off diagonal. then when i hit a button the door slides diagonally left and up, slides right, then back down to starting position. the door on the right is almost perfect, it goes up, waits the set amount of time then comes back down.

why would the door appear crooked when inside hammer it appears perfect.
also the buttons are set up to make both doors open no matter which button is hit.

edit** just played it again, the door actually goes down first, then goes up, then gets stuck, slides over n finally comes back down. wish i could post a demo of it.

SECOND question..... when the door slides it is still slightly visible through the wall it slides into. How can i stop that???? If it slides up it comes out of the wall, anyway to turn the door invisible after it leaves starting position???




Quote
 Re: crooked door bad door
Posted by Bobv on Tue Jan 25th at 12:29am 2005

well i dont undurstand what you mean for the first part, honestly.


If you dont want your door to slide into the wall completely and stick out a little set the "lip" value to a small number - like 3. If you want it to go INTO the wall set to a negative number




Quote
 Re: crooked door bad door
Posted by Snookay on Tue Jan 25th at 12:42am 2005

the first paragraph means.... the door IS diagonal inside the door jam. crooked. looks like it was kicked off the hinges and hasnt fallen down yet. .... ummm its sideways. but when viewing inside of hammer it looks fine in the door jam.

how do i post my pics on this website, do i have to link from another website.




Quote
 Re: crooked door bad door
Posted by DrGlass on Tue Jan 25th at 1:29am 2005

Give both doors seperate names, then under the door direction set the pitch yaw roll to 'up' or 'down'
[addsig]




1
Post Reply