crooked door bad door

ok i made 2 doors and 4 buttons. 1 button on each side of
both the doors. the door on the left is bad, the door on the
right is good. I shoot or press button and the doors are suppoes
to go down or up. well the door on the left starts off
diagonal. then when i hit a button the door slides diagonally
left and up, slides right, then back down to starting position.
the door on the right is almost perfect, it goes up, waits the set
amount of time then comes back down.

why would the door appear crooked when inside hammer it appears perfect.

also the buttons are set up to make both doors open no matter which button is hit.

edit** just played it again, the door actually goes down first, then
goes up, then gets stuck, slides over n finally comes back down.
wish i could post a demo of it.

SECOND question..... when the door slides it is still slightly
visible through the wall it slides into. How can i stop
that???? If it slides up it comes out of the wall, anyway to turn
the door invisible after it leaves starting position???

well i dont undurstand what you mean for the first part, honestly.

If you dont want your door to slide into the wall completely and stick
out a little set the "lip" value to a small number - like 3. If you
want it to go INTO the wall set to a negative number

the first paragraph means.... the door IS diagonal
inside the door jam. crooked. looks like it was
kicked off the hinges and hasnt fallen down yet. .... ummm
its sideways. but when viewing inside of hammer it looks fine in
the door jam.

how do i post my pics on this website, do i have to link from another website.

Give both doors seperate names, then under the door direction set the pitch yaw roll to 'up' or 'down'